LockedHow To - Set the delay between IPSentry monitoring cycles.

Author
IPSentrySupport
Support Guy
  • Total Posts : 2059
  • Scores: 0
  • Reward points: 0
  • Joined: 2006/05/16 21:55:52
  • Status: offline
2007/08/20 20:56:34 (permalink)
0

How To - Set the delay between IPSentry monitoring cycles.

IPSentry monitors entries in sequential order (alphabetically and grouped).  At the end of each cycle, there is a delay that allows IPSentry to remain idle, perform cleanup processing, and other tasks that might interfere with the monitoring process if these tasks were performed in the background.  You may wish to adjust this delay based on the frequency at which IPSentry should monitor the devices.

  1. From the IPSentry active display console, select Action, System Options
     

  2. On the General tab you will need to modify the Pause Between Cycles field value.
     

  3. This value can be defined as Minutes or Seconds. 
     

  4. Press OK to save the changes.

---
IPSentry Support
RGE, Inc.
http://www.ipsentry.com
http://forum.ipsentry.com

IPSentry® is a Registered Trademark of RGE, Inc.
#1

0 Replies Related Threads

    Jump to:
    © 2017 APG vNext Commercial Version 5.5